Hello and welcome to the newsletter once again.
As always things have been ticking along and lots of things happening here- not least because of our current (and long term….) volunteer Tim, who is young fit and enthusiastic, and has helped move us swiftly through a long list of tasks to the point where we actually feel like we might be ‘on top’ of things for a while.
Amongst these projects has been the Solar Water Heating panels.
Initially my thoughts were to purchase aluminium clip on solar fins from the Centre for Alternative Technology (CAT)- these I have used before in the several systems I have built. On looking however I found they were no longer for sale. We eventually settled on a plan- since we had recovered the aluminium sheeting from the outer of our mobile home we would manufacture our own clip fins…..
After a few trial goes, we settled on a jig that worked, and wearing ear defenders proceeded to hammer out the slots in the cut rectangles of aluminium sheeting. We used a 15mm steel bar (from a well known on line auction site….) and the jig from scraps of wood and angle steel.
We used a Header/Footer and riser layout for the pipework- 22mm for the main Head/Foot and from panels to the cylinder, 15mm for the risers which the fins clip to….
After soldering each of the four panels up, we installed the fins using silicone to fill the small gap between fin and pipe (silicone conducts heat better than air…). A slap on of matt black paint, and we moved to the installation.
As those who have read earlier posts on the house blog site may recall, the outdoor kitchen roof pitch was set to get the best average summer sun, and our intention was to mount the panels into the rafters of the roof. This inevitably meant removing the polycarbonate roofing sheets, and drilling holes in perfectly good rafters…. a window of good weather was needed and we were lucky it happened just as we were ready to install.
More soldering, lots of awkward ladder positions and messing about balancing on narrow bits of wood, and we had the panels in place. We backed them with more aluminium sheeting and insulated with the remains of our old futon mattress… hoarding things that ‘might be useful one day’ sometimes pays off!
The pipework to the cylinder was the next challenge- hindsight is a wonderful thing and it showed me that I should have left myself better access to the hot water cylinder- I had to cut a hole in the wall between Elowens’ room and the airing cupboard- messy and awkward, and has left me another thing to tidy up. Ah well!
Drilling through straw walls is interesting!
Without further minutae of detail suffice to say I managed to plumb the system in and solve the few small leaks in solder joints. The indications thus far are that all will work fine- but we have not had a good hot day to properly show this to be the case….. I will keep you updated.
As with any of these posts if you would like further information or to chat about stuff we have done get in touch.
Please pass the newsletter details on to anyone you think might be interested,
Click on the subscribe button in the menu above.